GO Jiaju
Now many people like to install the embedded bathtub, which is both beautiful and atmospheric, but how to install the embedded bathtub, what should be paid attention to?
1. Matters needing attention
1. The low walls or ribs around the bathtub must have sufficient support, and the surrounding sand should be compacted;
2. Do not use bricks or other hard objects to support the bottom, so as not to damage the glaze during use;
3. The bottom and four peripheral corners should be in contact with the full force evenly;
4, note that the overflow pipe and the drain pipe at a joint tightly coupled;
5. Leave the sewerage access port when attaching tiles. In order to make the surface look good, you can use glue to stick the tiles on the maintenance port, so that it can not be seen from the outside, and it is convenient to remove the tiles during the maintenance;
6. Install the water fittings before placing the bathtub, and do a 24-hour water shut-off test to see if there is water leakage at each joint;
7. When placing the bathtub, pay attention that one end of the drain is slightly lower than the other end. The outer end is slightly lower than the inner end;
8. The actual size of the bathtub may not be exactly the same as the nominal size. Measure on the spot when purchasing and installing, and reserve normal tolerances to facilitate installation;
9. The sewer pipe should be slightly inverted s-shaped to prevent back odor.
Second, the installation method
1. Preparation
We need to choose the suitable bathtub according to the specifications of the bathroom in advance, and don't buy it if you look good. Secondly, we must pay attention to leaving other vacancies in the bathroom, so that we can place other furniture in the future. Finally, we are ready to install the spanners , wires, bricks and tiles necessary for the built-in bathtub.
2. Method steps
The installation of built-in bathtub should take into account factors such as load-bearing, waterproof, maintenance, aesthetics, performance and so on. Most are installed at one end of the bathroom. Specific steps:
(1) After the pipeline is completed, the slotted parts are repaired for waterproofing, and the 24-hour water storage test ensures no leakage.
⑵, we first build a contour with brick cement, affix the tile we like on the periphery of the skirt, and also build a platform with ceramic tiles in the contour.
⑶, use foam brick to cushion the bathtub, the height of the bathtub is generally within 600mm. Connect the upper and lower water to keep it smooth. Then use foam brick to build the wall and plaster. Pay attention to keep the manhole in the corresponding position of the sewer, about 250x300mm.
â‘· Next, wait for the cement to dry. After stabilizing, we connect the embedded bathtub sewer pipes, and point-to-point snap into the pre-built outline.
⑸, what kind of material is used on the table, you can use the same style of wall tiles, mosaic, artificial stone , marble , stainless steel , etc., depending on the style you like.
⑹, glass glue is attached to the wall where the embedded bathtub is installed, which can effectively prevent the bottom from being damp and can effectively extend the life of the bathtub
The above content is provided by GOJia.com
N95 Mask Machine,Mask Blank Machine,N95 Cup Mask Machine,Dust Mask Making Machine
Dongguan Huitong Automatic Machinery Technology Co., Ltd , https://www.medicalmaskmachines.com