Xingrong Gaoke launched a new copper-aluminum composite pipe

Jiangsu Xingrong High-tech Co., Ltd. recently stated that its copper-aluminum composite pipe (ACC pipe) produced by patent technology can improve product energy efficiency. The product is a copper-clad aluminum structure, which utilizes the good thermal conductivity of copper and the good specific heat value of aluminum to increase the heat transfer rate. According to reports, Xingrong has successfully achieved metallurgical bonding between copper and aluminum using patented technology. The light pipe used in air conditioning condenser can achieve the same heat transfer effect as the internally threaded copper pipe. When both machines use the internal thread ACC tube, the energy efficiency ratio is 5% higher than that of the internal thread copper tube; each air conditioner reduces the cost by about 150 yuan, which is the replacement of the air conditioning tube.
Copper-aluminum composite pipe is mainly used in air conditioner evaporators and condensers, refrigerator condensers and evaporators, refrigerator connecting pipes, central air conditioners, fan coils, water heater pipes, heating radiators, water pipes and the like.
According to the data provided by Xingrong Company, the tensile strength of copper-aluminum composite pipe is 110-130MPa, the bursting pressure is above 18MPa, and the flare ratio can reach 40%-50%. The inner surface cleanliness, flattening, bending and anti-wear Leakage and other indicators fully meet the requirements of air conditioning pipe standards. The tube area copper area ratio is 12% to 14%, the weight ratio is 31% to 38%, and the normal specific gravity is 3.45g/cm3. The main specifications of the two tubes are: φ9.520.5mm, φ7.940.5mm; φ70.5mm.

Panel Light

We supply various panel light, including surface mounted panel light LED, recessed ceiling light, slim panel light etc.

The below information will help you to know more about panel light.

What is a panel light?

Panel lights are used residentially and commercially and replace traditional fluorescent ceiling lights. They can be mounted on various types of surfaces, including recessed ceilings or suspended grid ceilings. Because they are smooth, they provide a flat wall of light without noticeable bulbs

Types of LED Panel Lights

Commonly, they are available in two categories: surface-mounted and recessed ones.

Surface-mounted LEDs – The surface-mounted ones appear to be thicker than the recessed ones as they are structured to match broader surfaces. There is no requirement of cutting the mounting hole as it is attached to the bracket by screwing it.

Recessed LEDs – They are the slimmest ones available in the market. They are framed to fit in the mounting surface. A cutout hole is required in the mounting surface to fit them with side springs that hold them.

Where to Use Panels?

LED panels can be the most eligible substitute for the prevailing illuminator setup, saving power consumption. Many houses still have pennant or flush illuminators or downlights that can be refurbished using them to get a new trendy look.

The flexibility of LEDs is that they can be used anywhere without any hindrance. They are much brighter and give you more clear brightness. You can install these in your hall, kitchen, bathroom, and living room.

In case you have a plan to renovate your house`s illuminating system, you can choose these instead of ordinary bulbs and tubes. Generally, the mounting surface determines the type of light you may use. Recessed ones can be used over plasterboards and plywood or on thin MDF as they can be cut effortlessly for making a hole.

As brick and timber cannot be reduced to make a hole, you can use surface-mounted ones over here. Brackets are accommodated into which they are screwed easily.

panel light

Panel Light ,Indoor Panel Light ,Inside Led Panel Light,Smart Led Panel Light

NINGBO LONGFLIGHT INTELLIGENT TECHNOLOGY CO.,LTD , https://www.long-flight.com