The sauna installation must pay attention to two aspects, one is the insulation of the sauna room, on the other hand, the sauna room is too windy.
Sauna insulation
Disinfectant Pools The walls, ceilings and doors of the sauna room should be suitable for insulation treatment. When measuring the heater power request, a volume of about 1.2 cubic meters per square meter of uninsulated detail will be added.
[1] It is necessary to hold a suitable moisture-proof treatment. The guideline is to press the humid gas into the other room about the wall, and the moisture-proof installation should be installed between the heating insulation layer and the slat.
The insulation and moisture-proof installation of the swimming pool washing machine sauna should be installed from the outside to the inside according to the following rules.
1. The thickness of the wall insulation layer should not be lower than 50 sisters, and the ceiling thickness should not be less than 100mm.
2, the best about to operate the carton or aluminum foil as a vapor barrier distance layer, installed above the insulating aluminum foil.
3. Leave at least 20 mm of air slots between the vapor barrier distance layer and the outer slats.
4. In order to press the back of the slats to moisten the gas, a groove should be reserved between the wall panel strip and the ceiling.
Sauna too windy
In order to soothe the effect of the sauna, it is advisable to mix the wrong proportions of hot and cold air in the sauna. Another cause of the wind is to receive the air around the heater and transfer it to the far end of the room. The central air outlet of the air is about to be rescued according to the pleasure of [1] and the happiness of Xiqiao.
The installation of the air inlet of the Guangzhou Anda Technology sauna room should be directly placed on the wall below the electric heater. When the operation is forced to exceed the wind, the air inlet should be placed above the electric heater above 60cm or above the ceiling of the electric heater. After these winds and vents, the heavier cold air enters the sauna room and mixes with the lighter hot air of the electric heater, so that the bather can breathe in the strange air. Advocate the size of the air inlet is 5-10cm, and the exhaust port should be placed in the center of the diagonal position on the face of the air inlet.
Advocate the installation of the exhaust port below the platform installed in the sauna, not to mention even though it is not a gas exchange. The exhaust port is placed around the floor, or the exhaust pipe from the bottom is extended from the underground to the ceiling of the sauna or the air vent under the door. In this environment, the chute should reach at least 5cm, not to mention the washing room should be rejected to force the wind. The size of the exhaust port should be twice that of the air inlet.
The sauna is made of white pine which is treated with high temperature and is insulated with insulating cotton. It may be selected in detail according to the product specifications. The sauna room can also be used according to the size of the number of people involved, according to the size of the multi-standard management, there are many specifications.
Loose Lay,Grain Indoor Easy Pave Flooring,Indoor Easy Pave Flooring Loose,Durable Indoor Easy Pave
DONGYANG MAOSHENG PLASTIC CO.,LTD , https://www.maoshengflooring.com