Well submersible pumps are important equipment for pumping water from deep wells. When used, the entire unit dives into the water and extracts groundwater to the surface. But in the actual work, there will be common failures of the well submersible pump. The following is the introduction of the common faults and elimination methods of the well submersible pump introduced by Youfu Pump.
Well submersible pump common fault causes and their elimination
Symptoms: No water, no water or intermittent water.
Causes: 1 motor reversal; 2 motor does not start; 3 dynamic water level is lower than the suction inlet; 4 pipeline or connection site serious leakage; 5 pump seal ring or impeller is seriously worn out; 6 motor and pump coupling sleeve shake . Remedy: 1 exchange the location of the contacts; 2 remove the line failure, check the voltage; 3 increase the riser or replace the water pump; 4 overhaul the pump to eliminate the fault; 5 replace the seal ring or impeller; 6 fixed joints.
Symptom: Reduced traffic.
Causes: 1 The seal ring is worn out; 2 The filter is blocked; 3 Water leaks between the riser or the housing. Remedy: 1 remove the pump to replace the seal ring; 2 remove the pump to repair the water filter; 3 remove the pump to repair and eliminate the fault.
Fault phenomenon: The unit vibrates violently.
Causes: 1 The shaft of the pump is bent; 2 The bearings of the pump and the motor wear excessively. Remedy: 1 Dismantle the pump to correct the shaft or replace it; 2 remove the pump or motor, repair the bearings.
Well Submersible Pump Common Faults and Troubleshooting Methods
Fault phenomenon: The ammeter pointer swings large.
The reasons are as follows: 1 The dynamic level drops to the pump inlet; 2 The flow rate is too large, causing the pump rotor to string. Remedy: 1 increase the water pipe or replace the water pump; 2 close the valve to reduce the amount of water.
Symptom: The insulation resistance drops below 0.5MΩ.
The reasons are as follows: 1 The quality of the cable connector is not high; 2 The motor insulation is damaged; 3 The cable is damaged. Remedy: 1 reconnect the cable connector; 2 repair the motor windings; 3 repair or replace the cable.
Symptoms: The motor does not turn on when starting and there is a buzzing sound.
Causes: 1 Single-phase operation of the motor; 2 bearing engagement axis. Remedy: 1 Check the power cable, find out the phase; 2 repair or replace the bearing.
Youfu is committed to continuous improvement of pump technology, products and solutions. Yufu provides submersible pumps, surface pumps, deep well pumps, sewage pumps, pump system products and after-sales services to provide tailor-made solutions.
In the future, Yufu will continue to develop more energy-efficient, environmentally-friendly and cost-effective pumps and pump systems, and is committed to growing into a more specialized and comprehensive international fluid equipment supplier.
(This article is edited and published by Asian Fluid Network. Please indicate the Asian fluid network. For business inquiries, please contact QQ. Editor: Huang Feini)
1.ideal tool for furniture manufacture
2.With Bigger Cylinder designing,more powerful
3.High performance and low maintenance
4.Comfort rubber handle minimize operator's fatigues
5.360 degree exhaust cover
6.T Brad Nailers Series is the ideal tool for upholstery and furniture manufacture.
7High performance and low maintenance.
100% spare parts can be offered to you!
T Brad Nailers
T Brad Nailers,Brad Nailer,Electric Brad Nailer,Pneumatic Nailer
DAHOO Tools Co., Ltd. , http://www.dahootools.com