30 auto companies such as Guangqi Honda are scheduled to be suspended for new energy vehicles for at least 1 year.

Abstract On September 3, the Equipment Industry Development Center of the Ministry of Industry and Information Technology issued the "Notice on Publicizing the List of Enterprises to Be Reported". The notice stated that it plans to stop producing new energy vehicle products for 12 months or more...

On September 3, the Equipment Industry Development Center of the Ministry of Industry and Information Technology issued the "Notice on the Publicity of the List of Enterprises to be Reported to the New Energy Vehicle Manufacturers (First Batch)>. The notice stated that it plans to stop producing new energy vehicle products for 12 months. The list of enterprises above and above (according to the number of certificates uploaded) is reported to the Ministry of Industry and Information Technology. There are 30 companies in this batch list, including Brilliance Auto, Hafei Automobile, and Guangqi Honda.

2.jpg

The following is a list of specially announced new energy vehicle manufacturers (first batch) to be reported:

微信截图_20180904091344.png

微信截图_20180904091354.png

Gas Industry Mass Flow Meter

Sealand is a trustworthy manufacturer of Gas Mass Flow Meter, Gas Mass Flowmeter, Gas Flow Meter, Gas Flowmeter, Gas Meter, ATEX, IECEx & CE approved.



The installation is as follows.

1. Installation Steps
a) Choose correct installation site, taking installation area, pipeline, transmitter location &

valve location into consideration;
b) Install the meter according to direction mark on sensor; c) Install the sensor & transmitter on pipeline;
d) Connect transmitter & sensor with 9-pin cable;
e) Start.


2. Site selection

a) Sensor stays away from mechanical vibration source, for example, pump. Use flexible pipe to connect meter with pipeline if inevitable. The housing of meter must be standalone, out of touch with any other device. There must be 3 times the size of sensor between 2 sensors if there are many flow meters on the same pipeline, to avoid resonance.

b) Do not install sensor on pipeline that easily expands with hot and contracts with cold, especially near expansion joint, which leads to a worse stability.

c) Sensor stays away from industrial electromagnetic field, such as large generator and transformer, better 5m at least. Such device influences the performance of drive coil and pickoffs. Make sure magnetic field intensity less than 400A/m.

d) Sensor shall be installed on lower pipeline, to be easily full of fluid.
e) Make sure Ex-mark meet application requirements if in hazardous area.

f) Build a sunshade if the meter is under direct solar radiation. g) Keep the meter from corrosive liquid.


Gas Mass Flow Meter, Gas Mass Flowmeter, Gas Flow Meter, Gas Flowmeter, Gas Meter

Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeter.com